Bulk bag sewing machine

Latest articles



Popular articles

Latest articles

  • The application of electric welding net is more widely, at present it has replaced the use of other parts of the wire mesh, the cost of electric welding net is lower, the production speed is very fast, so it is very popular. Welding net galvanized before the need for processing is recrystallization annealing, because the welding net must maintain a no oxide and no other impurities of pure iron active surface, if you can not keep its surface clean will lead to a bad galvanizing effect, galvanized layer and iron material is not closely combined, so this step is necessary.

  • “Wet” hot dip galvanizing is also called “molten solvent method” hot dip galvanizing. Iron and steel workpiece through degreasing, pickling and cleaning, it is necessary to set in a special box above the surface of the molten zinc in the “molten solvent” (also called cosolvent), and then into the zinc liquid to galvanized. The molten solvent is usually a mixture of ammonium chloride and zinc chloride, but also other chlorine salts.

  • The main raw material of blade barbed rope is galvanized wire and galvanized sheet, because the price of galvanized sheet is more expensive than galvanized wire, so it is directly reflected in the price of the sales of blade barbed rope. There is also the difference in processing technology also led to the difference in the price of the blade thorn rope. The traditional barbed rope is mechanically twisted, which uses less labor and has high production efficiency. But the blade is after two mechanical processing in the manual processing operation before the appearance. So whether from the labor force or from the production efficiency also said there is a large gap. These factors lead to the price of blade thorn rope is more expensive the main factor.

  • Magnetic test method is the original common difference between austenitic stainless steel and ferritic stainless steel simple way, austenitic stainless steel is wrong magnetic steel, but after cold processing under large pressure will have a slight magnetic; But pure chrome steel and low alloy steel are strong magnetic steel.

  • Material: low carbon steel wire
  • barbed


  • Post time: 08-09-22
  • black


  • Post time: 01-08-22

  • Post time: 19-09-22
  • 1. Used for mountain farming, road isolation, large farming enclosure protection, it is recommended that you choose 3mm wire diameter products.


  • Post time: 24-03-23

  • Post time: 25-10-22
  • 2.25*2.25mm 10 meters per kilogram
  • The wire rod should be normalized or soxhlet processed, instead of spheroidal annealing for standard large ones. Soxhlet process is widely used in the heat treatment of the center, especially the products before drawing. Avoid decarbonization during heat treatment. After heat treatment, sulfuric acid or hydrochloric acid pickling is used to remove iron sheet. The coating (see smooth carrier) can be dip-lime, phosphating, borax treatment or copper plating.

  • iron

  • barbed

  • galvanized

  • Due to the implementation of the grassland contract operation obligation system, herdsmen have a high capacity to strengthen and raise their stainless steel barbed rope fence net in grassland pastoral areas, forming the phenomenon of high density and high height of stainless steel barbed rope fence net in grassland pastoral areas, which is destructive and even destructive to the survival of wild animals.

  • No matter how good the quality of hot-dip galvanized barbed rope is, it is only attached to the surface of the wire with galvanized layer, and with the cause of chemical reaction, the zinc layer on the surface will gradually lose its effect because of oxidation reaction, which is more prominent in the humid area of the environment. And because, after all, the wire will rust, so the quality of hot-dip galvanized barbed rope is certainly not up to the level of stainless steel barbed rope.

  • This material itself has the advantages of good integrity, uniform force, high strength, wear resistance, corrosion resistance and so on. Moreover, the production process is simple and the degree of industrialization is high, so its economic benefits are better than other metal mesh materials. In some industrially developed countries, this material has long been used in urban and rural roads, tarmac runway is also widely used. The application of galvanized wire welding net in the construction industry is countless, and the application of galvanized wire welding net in the construction industry has been greatly developed.

  • When the temperature is running at the same temperature and the same heat is stored, the amount of iron dissolved is not the same. At around 500, the loss of iron increases sharply with the addition of temperature and insulation. It is lower or higher than 480~ 510c, and the loss of epitaxial iron is slower, and it is difficult to catch up with the duration. Therefore, everyone will call 480~ 510c the malignant melting zone.
  • The installation of guardrail should also follow certain steps, first of all, after the guardrail is transported, according to the length of the guardrail, determine the distance between the column, if the installation of the guardrail field is soft ground, then you can first dig out a 40*40*50cm embedded machine base. If it is a concrete floor, as long as the expansion bolt directly fixed.

  • 2, PVC coated barbed rope has strong corrosion and turbidity resistance
  • 牛栏网

  • Cleaning and disinfection methods of pet dog cage:


  • Post time: 24-04-23
  • galvanized

  • Wire-wall welding net is widely used in industrial production, agriculture, engineering construction, transportation, mining and other processing and manufacturing industries. Such as machinery and equipment protective cover, animal guardrail, pot flower guardrail, window fence, safety exit guardrail, poultry cage, egg basket and home office food industry basket, paper basket and design decoration. It is suitable for general engineering building wall, pouring concrete, multi-storey building, etc., which plays an important structural role in the thermal insulation system. In the construction of the building, the thermal insulation board of hot-dip galvanized electric welding grid is placed on the inside of the outer mold of the wall to be concreted. The external thermal insulation board and the wall are one kind of live, and the thermal insulation board and the wall are integrated into one body after the removal of the mold. The coating on the surface of the weld core is called the coating. The coating of electrode plays a very important role in the welding process. If the photoelectrode without drug skin is used for welding, in the welding process, oxygen and nitrogen in the air will invade a large number of molten metal, metal iron and beneficial elements such as carbon, silicon, manganese oxidation and nitriding to form various oxides and nitrides, and residual in the weld, resulting in slag inclusion or cracks in the weld. The gas in the weld pool may produce a large number of pores in the weld. These factors can greatly reduce the mechanical properties of the weld and make it brittle.

  • Because the coating obtained is thicker, hot-dip galvanizing has very good protective function than electric galvanizing, so it is an important maintenance coating for iron and steel parts in strict working environment. Hot-dip galvanized products are widely used in chemical equipment, petroleum processing, Marine exploration, metal structure, electric power transportation, shipbuilding and other occupations. In the field of agriculture, such as pesticide irrigation, greenhouse and construction industry such as water and gas transportation, wire casing, scaffolding, Bridges, highway guardrail and other aspects, it has been widely used in these years.


  • Post time: 09-06-22
  • 5, there are no special requirements: such as whether to shrink packaging, etc.