fully automated sewing machine

In the meantime, the chemical factories of Continental Europe, principally in Germany, Austria and Belgium, had taken hold of the novelty and under the collective name of lithopone or lithophone, by numerous processes, produced various grades of the pigment, branding the respective qualities as red seal, green seal, yellow seal, blue seal, etc., or selling them under some fancy name. Of this we shall speak later on. The crusade against the use of white lead in the various countries of Continental Europe, assisted the manufacturers, to a very great extent, in marketing their products, not only to industrial concerns, as has been the case in this country, until recently, but to the general painting trade. Up to 1889 the imports into this country were comparatively small. At that time one of the largest concerns manufacturing oilcloth and linoleum in the State of New Jersey began to import and use Charlton white. Shortly after that other oilcloth manufacturers followed suit, replacing zinc white with lithopone in the making of white tablecloth, etc., and later on abandoning the use of white lead in floor cloth and linoleum. This gave an impetus to several chemical concerns, that erected plants and began to manufacture the pigment. Competition among the manufacturers and the activity of the importers induced other industries to experiment with lithopone, and the shade cloth makers, who formerly used white lead chiefly, are now among the largest consumers. Makers of India rubber goods, implement makers and paint manufacturers are also consumers of great quantities, and the demand is very much on the increase, as the nature of the pigment is becoming better understood and its defects brought under control. Large quantities find their way into floor paints, machinery paints, implement paints and enamel paints, while the flat wall paints that have of late come into such extensive use owe their existence to the use of lithopone in their makeup.

The first study addressing the experimental convergence between in vitro spiking neurons and spiking memristors was attempted in 2013 (Gater et al., 2013). A few years later, Gupta et al. (2016) used TiO₂ memristors to compress information on biological neural spikes recorded in real time. In these in vitro studies electrical communication with biological cells, as well as their incubation, was investigated using multielectrode arrays (MEAs). Alternatively, TiO₂ thin films may serve as an interface material in various biohybrid devices. The bio- and neurocompatibility of a TiO₂ film has been demonstrated in terms of its excellent adsorption of polylysine and primary neuronal cultures, high vitality, and electrophysiological activity (Roncador et al., 2017). Thus, TiO₂ can be implemented as a nanobiointerface coating and integrated with memristive electronics either as a planar configuration of memristors and electrodes (Illarionov et al., 2019) or as a functionalization of MEAs to provide good cell adhesion and signal transmission. The known examples are electrolyte/TiO₂/Si(p-type) capacitors (Schoen and Fromherz, 2008) or capacitive TiO₂/Al electrodes (Serb et al., 2020). As a demonstration of the state of the art, an attempt at memristive interlinking between the brain and brain-inspired devices has been recently reported (Serb et al., 2020). The long-term potentiation and depression of TiO₂-based memristive synapses have been demonstrated in relation to the neuronal firing rates of biologically active cells. Further advancement in this area is expected to result in scalable on-node processors for brain–chip interfaces (Gupta et al., 2016). As of 2017, the state of the art of, and perspectives on, coupling between the resistive switching devices and biological neurons have been reviewed (Chiolerio et al., 2017).