The toxicity of P25TiO₂NPs was evaluated in both prokaryotic (Fig. 3) and eukaryotic cells (Fig. 4). The XTT assay was chosen to measure the cell viability in bacterial cultures of MSSA, a normal skin microbiota microorganism. The reduction in the viability of samples with bare NPs is notorious, possibly due to the described ROS production from the interaction of P25TiO₂NPs with light [37]. This effect seems to be avoided when they are functionalized with vitamin B2. Also, the most concentrated vitaminB2@P25TiO₂NPs sample (0.2 mg/mL) shows up to 60% more absorbance after 6 h compared to the bare NPs (due to normal cell replication). This may indicate that the antioxidant effect of the vitamin B2 coating is greater than the oxidation damage produced by the NPs. This protective capacity could be attributed to the glutathione redox cycle and the conversion of reduced riboflavin to its oxidized form [38]. Values of cell viability greater than 100% are not rare and could be understood because the XTT assay actually measure metabolic activity when reducing the tetrazole to formazan. It is usually assumed that conversion is dependent on the number of viable cells, but it could also be related to an expected increased enzymatic activity when cells are exposed to small doses of some new substance. Further analysis showed that this effect was not the only one responsible for better cell viability of vitaminB@P25TiO₂NPs treated samples.

The basic scenario of resistive switching in TiO₂ (Jameson et al., 2007) assumes the formation and electromigration of oxygen vacancies between the electrodes (Baiatu et al., 1990), so that the distribution of concomitant n-type conductivity (Janotti et al., 2010) across the volume can eventually be controlled by an external electric bias, as schematically shown in Figure 1B. Direct observations with transmission electron microscopy (TEM) revealed more complex electroforming processes in TiO₂ thin films. In one of the studies, a continuous Pt filament between the electrodes was observed in a planar Pt/TiO₂/Pt memristor (Jang et al., 2016). As illustrated in Figure 1C, the corresponding switching mechanism was suggested as the formation of a conductive nanofilament with a high concentration of ionized oxygen vacancies and correspondingly reduced Ti³⁺ ions. These ions induce detachment and migration of Pt atoms from the electrode via strong metal–support interactions (Tauster, 1987). Another TEM investigation of a conductive TiO₂ nanofilament revealed it to be a Magnéli phase Ti_nO_2n−1 (Kwon et al., 2010). Supposedly, its formation results from an increase in the concentrations of oxygen vacancies within a local nanoregion above their thermodynamically stable limit. This scenario is schematically shown in Figure 1D. Other hypothesized point defect mechanisms involve a contribution of cation and anion interstitials, although their behavior has been studied more in tantalum oxide (Wedig et al., 2015; Kumar et al., 2016). The plausible origins and mechanisms of memristive switching have been comprehensively reviewed in topical publications devoted to metal oxide memristors (Yang et al., 2008; Waser et al., 2009; Ielmini, 2016) as well as TiO₂ (Jeong et al., 2011; Szot et al., 2011; Acharyya et al., 2014). The resistive switching mechanisms in memristive materials are regularly revisited and updated in the themed review publications (Sun et al., 2019; Wang et al., 2020).

There seems to be a lot of misunderstanding about titanium dioxide, which can be used as a colorant in foods. While headlines may suggest titanium dioxide is a health concern, scientific research has actually shown titanium dioxide to be safe. So what is it used for and why is it used? Read on to learn more!

Furthermore, the use of titanium dioxide in rubber helps to reduce the environmental impact of rubber manufacturing processes. As a non-toxic and environmentally friendly material, titanium dioxide is safe for use in rubber products that come into contact with food, water, or other sensitive materials. This makes it an attractive choice for manufacturers looking to produce eco-friendly and sustainable rubber goods.

Lithopone is a mixed zinc sulfide-barium sulfate brilliant white pigment that contains about 30% zinc sulfide. The original light sensitiveness of this pigment has been mitigated by purification and by the addition of such agents as polythionates and cobalt sulfate.

Production of TiO₂ Pigment

In 2016, the European Food Safety Authority, or EFSA, assessed titanium dioxide and determined that the evidence available at the time didn’t conclusively point to any health problems for consumers. 

Does It Cause Cancer?