auto stitching machine

In garment production, the ability to create decorative stitching enhances the aesthetic appeal of clothing items. Designers often use swing needle machines to add unique touches, such as embroidered logos or intricate hems, which can elevate a piece from simple to spectacular. In upholstery, the durability and versatility of swing needle stitching ensure that seams can withstand the wear and tear associated with daily use, making these machines a preferred choice for professionals.

Nitrile is the most widely used rubber (elastomer) and it’s recommended as the best for almost all standard applications. This is solely due to the fact that nitrile has some intrinsic properties, such as low cost and compatibility with most environments. Some of the general applications of nitrile are non-latex gloves, automotive transmission belts, footwear, gaskets, synthetic leather, hoses, o-rings, and oil seals.

Under the action of the skeleton oil seal, the rigidity of the oil film just makes the oil film and the air contact end form a crescent surface, which prevents the leakage of the working medium and realizes the sealing of the rotating shaft. The sealing ability of the oil seal depends on the thickness of the oil film on the sealing surface. If the thickness is too large, the oil seal will leak; if the thickness is too small, dry friction may occur, causing the oil seal and shaft to wear; if there is no oil film between the sealing lip and the shaft, it is easy to cause heat and wear. . Therefore, when installing, it is necessary to apply some oil on the sealing ring, and at the same time ensure that the skeleton oil seal is perpendicular to the axis line. If it is not perpendicular, the sealing lip of the oil seal will drain the lubricating oil from the shaft, which will also lead to excessive sealing of the lip. wear. During operation, the lubricant in the casing seeps out a little, so that it is ideal to form an oil film on the sealing surface.

Standard 3760/3761

There is a British Standard laid down for the control of synthetic rubbers. BS 3574 (1989) helps to determine shelf life – for instance, Nitrile (NBR) and Polyacrylic (ACM) are Group ‘B’ rubbers and have a 7-year life, whilst Silicone (VMQ) and Fluoroelastomers (Viton®) are Group ‘C’ rubbers and have a 10-year shelf life. PTFE and Leather do not come into this category but like the others should be kept in the original packing for as long as possible away from direct light, dust, and humidity. Ozone, which can also be produced by battery-driven forklift trucks has a very bad effect on synthetic rubbers. Finally, protect the sealing lip – DO NOT hang the seals on nails, wire etc.

Slowly raise the engine about 11 in. (38 mm) and insert wedges between the mounting rubbers and pads .

The edge of the metal is finely ground after seal manufacture in a centerless grinder to enable an interference fit in the oil seal housing. A slight chamfer on the outer diameter (OD) of the seal is desirable for easy assembly. The sealing lip is prepared by buffing, grinding or cutting away the rubber flash which occurs at the sealing edge. A fine sealing edge creates sufficient pressure on the shaft to minimise spring load, leading to lower friction whilst maintaining effective seal performance. The garter spring plays an important role in the efficiency of the oil seal. If its tension is too high, heat will be generated between the sealing lip and the shaft, and result in rapid wear of the lip. If too low, the spring will be ineffective and the sealing lip will be worn away leading to leakage of the fluid.

In this way, selecting the appropriate oil seal will lead to machine design that is economically superior!

There are four general motor oil types: